I was surfing several differen sites this last week and came across this cool coasters. Who doesn't need coasters for drinks around the house? This DIY comes from www.theidearoom.net, great idea for a fathers day gift!
Today I have a new little project for those of you who drink your beverages out of a can or know someone who does. These will also be a great gift idea for Father’s Day…Soda Can Coasters.
Yes…that is my favorite drink of choice…that I no longer drink…Boo! Getting to old to be drinking my calories! But I can still enjoy looking at it when I place my ice water on my lovely new coasters!
Simply empty out some cans of your choice and rinse them out with water. Then take some tin snips and very carefully cut off the top and bottom of the can. This can be a bit tricky. **But be very careful as these cans are super sharp!!!! I suggest wearing garden gloves while cutting to help give you extra protection. I reenacted these photos because the gloves were not so pretty in the pictures…cause we all know how important that it! Be sure to save as much of the flat part of the side of the can so that you can get a nice size square for your coasters. Then cut down the seam of the can. Most cans will have a definite seam on the side…usually by the ingredient list.
Then I took some Silicone and put a good amount on the back of the square. I then attached them to some simple white tiles that measured 4 by 4 inches. I found them at Home Depot in the tile aisle and I believe they were 16 cents a piece. Flatten and rub the tin square so that it is securely attached. Wipe any excess Silicone off the top of the tile with a damp warm cloth.
Then I set a paper towel on the top of it and laid a pile of books on it and let them dry over night! The next day I took a small paint brush and painted some glossy varnish over the top of it to seal it all off so that the edges would not peel up and to protect the edges from poking or scratching any users of the coasters.
Then simply place some felt pads on the bottom of the coasters to protect your table top from getting scratched!
Aren’t they fun? I think they would be great to have in your TV room or game room.
And did I mention how inexpensive they are to make? Pennies per coaster! Really! And you are recycling with a purpose!
So go ahead and whip some of these bad boys up! One of the perks of this recent project was that I HAD to have one last drink. Really! There were no empty cans to be found! And I enjoyed every last drop. Who knows, I just may HAVE to make a LOT more of these coasters to give to ALL my friends and family!